Service & Repair
Fast diagnosis and expert fixes, 24 hours a day, on virtually any make or model.
ULT freezers (-80°C) · Repair & service
A -80°C freezer is the single most expensive thing to lose in most labs, and it fails in slow motion: a warm alarm at 2 a.m., a setpoint it can no longer hold, a compressor that runs and never rests. We repair, maintain, calibrate, and validate ULT freezers from every major maker, and we rent them when yours is down.
-80 alarming right now? Call and dispatch triages it with you now. Or send an emergency request and a dispatcher calls you back.
Upright and chest ULT freezers from -40°C to -86°C, cascade (two-stage) systems and the newer single-compressor and Stirling designs, plus the accessories that keep them honest: chart recorders, remote alarms, CO2 and LN2 backup systems, and door and gasket hardware.
High- and low-stage compressors, cascade heat exchangers, capillary tubes, and refrigerant charge on both circuits.
Controller boards, temperature probes, alarm relays, battery backup, and remote-alarm contacts wired to your monitoring.
Gaskets, inner doors, latches, heated door frames, and panel condition, the parts that decide how hard the compressors work.
CO2 and LN2 backup injection systems, tested under load so they open when the freezer needs them.
Most ULT calls come down to a few patterns. Frost builds behind a worn gasket, the door stops sealing, and the compressors run continuously. A condenser filter clogs and head pressure climbs until the high-stage trips. A slow refrigerant leak shows up as a freezer that holds -70°C but cannot reach -80°C. A probe drifts and the display lies. We diagnose each stage separately, because a fault in one circuit masquerades as a fault in the other.
We test the high and low stages separately with gauges and amperage readings, because a fault in one circuit masquerades as a fault in the other, and we check the probe against a reference before trusting the display.
Compressors on either stage, cascade heat exchangers, controllers and probes, gaskets and door heaters, and CO2 or LN2 backup valves, with the common parts on hand.
Pull-down and hold verified at setpoint, alarms and backup tested, compressor cycle times checked, and the display confirmed against the reference.
A written record of what failed and what was done, and a plain repair-or-replace recommendation when a unit is past its useful life.
A -80 that is slipping is treated as an emergency: call, and dispatch triages it with you while a technician is assigned. Rental ULT freezers are available, including 24-hour emergency placement, so your samples move once, not twice.
Preventative maintenance on a ULT is a filter and condenser cleaning, a gasket and door check, a defrost of the inner doors, a look at compressor amperage and cycle times, and a calibration of the display against a reference probe. On a schedule, that visit is what stands between a quiet freezer and a 2 a.m. phone call. When a repair will take time, we can place a rental ULT on your floor so the samples move once, not twice.
Brands
Linked brands have their own page. Not on the list? Ask. We service most makes and models.
Guides
Written by our technicians: what to check, what the numbers mean, and when to call.
The early signs an ultra-low freezer is in trouble, what you can check yourself in ten minutes, and when to stop troubleshooting and call for service.
Calibration, validation, and temperature mapping mean different things. What each one proves, and which one your auditor is actually asking for.
The checklist behind a preventative maintenance visit on a lab refrigerator, freezer, or ULT freezer: each task, how often it is done, and which ones you can do in-house.
Where
Ten Southern California counties from our Huntington Beach headquarters, and beyond by arrangement.
Los Angeles, Orange, Riverside, San Bernardino, San Diego, and Ventura counties are our core area. Santa Barbara, San Luis Obispo, Kern, and Imperial counties are on a regular route. Equipment that is already down jumps the queue, and our line is answered 24/7.
Outside Southern California we work by arrangement for contract and long-standing customers, and we say plainly what we can do and how soon.
Also from one team
Fast diagnosis and expert fixes, 24 hours a day, on virtually any make or model.
Scheduled upkeep on a cadence that fits each unit, so wear is found on a visit instead of as downtime.
New and used rental units, including 24-hour emergency availability when a unit goes down.
ULT freezers (-80°C) FAQs
Treat it as one. A freezer that has lost ten degrees is usually short on refrigerant or has a failing stage, and it tends to keep sliding. Call us, and if you have a backup freezer or CO2 backup, get it ready while we dispatch.
Yes. We replace and rebuild compressors on both stages of cascade systems, recharge to specification, and verify performance before we hand the unit back.
At least once a year for a filter and condenser cleaning, gasket and door check, and a calibration of the display. Freezers in warm rooms or with heavy door traffic benefit from a six-month schedule.
Yes. We keep rental ULT freezers available, including for 24-hour emergency placement, so your samples move once.
Ready when you are
Request service online in under a minute, or call. Our line is answered 24/7.
24/7 emergency service · Dispatch confirms every request by phone.